I Have Pulsations in my Baseline and Flow
Purpose
This article outlines potential causes and solutions to pulsations found in the baseline and flow.
Solution
Possible causes are as follows:
-
There is a leakage from the flow line. Tightening the fittings where the leak(s) is occurring will stabilize the flow.
-
Columns are not held by column clips properly to ground static electrical current. Make sure that the metal parts of the column are touching the clamps rather than the stickers/plastic.
-
The pump washing port does not contain enough ultrapure water. Please aspirate ultrapure water into the syringe.
Was this article helpful?YesNo