Functionality Articles

No Display Appears on the Control Panel for the Tomy MX Centrifuge

This article proposes that there might be an issue with the power supply to the unit causing the lack of display.

The issue may lie in needing to balance the items in the centrifuge or leveling the centrifuge itself.

Please ensure that the run time has been set. It will not start until the runtime is programmed.

This article provides steps to take to allow the autoclave to cool down properly.

This article gives a simple protocol to follow to open the lid.

This article outlines a procedure to make the ring fit onto the lid gasket.

Power connection from mains power to the unit might be the cause of no display.

This article provides some potential reason for why the temperature inside the autoclave rises at a slower than nominal rate.

This article outlines some reasons for the lid of an autoclave to not open.

The problem could stem from power not being supplied to the unit.