MX-Series Articles

No Display Appears on the Control Panel for the Tomy MX Centrifuge

This article proposes that there might be an issue with the power supply to the unit causing the lack of display.

The issue may lie in needing to balance the items in the centrifuge or leveling the centrifuge itself.

Please ensure that the run time has been set. It will not start until the runtime is programmed.

This article provides steps to take to allow the autoclave to cool down properly.

This article gives a simple protocol to follow to open the lid.

The motor boot will have to be replaced.

It is recommended to replace the deformed lid gasket.