Eicom Knowledge Base Articles

Priming Outlet Tubing for CX Probes for in-vitro use

This article gives guidance on how to properly prime CX probes for use in in-vitro set ups.

This article explains what column collapse is, some causes of column collapse, and a way to treat the separation column afterwards.

This article covers basic troubleshooting steps to follow when faced with low sensitivity on an HTEC system.

The procedure for repacking a precolumn is outlined in this article. It covers how to open/close, clean, and add packing material into the precolumn.

Once the pump on the HTEC has been disassembled, this tutorial will provide guidance on how to reassemble the pump.

This article provides instructions and a video on how to inspect the piston and piston seal of the HTEC pump.

This article provides a video and instructions on how to disassemble the pump head on an HTEC-510.

A video tutorial and instructions on how to use and wash the manual injector are contained within this article.

General Cannula information including cannula positioning, dead volume, and recommended flow rate are contained within this article.

In this articles are files to help calculate the dead volume of the microdialysis probes.

The composition and steps to make an antioxidant solution for catecholamines is listed within this article.

A procedure for how to clean the FC-90 by flushing the system with bleach and water is outlined within this article.