When attempting to connect a Bluetooth Android device to an FC-90, the inability to connect the devices may arise, and this solution aims to resolve that problem.
How to connect the FC-90 to an Android device via bluetooth
read more
Eicom Solutions Articles
My Retention Times Shortened Over the Course of one Month With a new Column
If retention times have shortened over a quick period of time, this article explains why it might have caused it and some steps to take to fix it.
I have Abnormally High Pressure When Replacing my Reduction Column in an ENO-30 System
If you experience high pressure when replacing the reduction column, following the recommendations in this article should bring your pressure back down.
Microdialysis Guide Cannulae or Implants are Falling off of the Skull.
This article outlines procedures to take to improve adhesion of implants to the skull of specimens.
The AS-700 Cooling System does not work.
The artile provides options for ways to check the status of the autosampler in software as well as provide guidance for visual ques to look for.
I Have Different or Large Solvent Front Peaks With an Autosampler.
This article outlines potential causes of differing front solvent peaks as well as a resolution to making the peaks consistent.
Issue With Frequent Bubbles in Pumps on ENO-20/30
This article explains the method to remove bubbles in the tubing that originate from the degasser.
Issue With the ENO-20 not Starting; Sequencer Error
This article outlines the steps to boot up the ENO-20 through reprogramming of the sequencer within the detection oven.
Issue With a Clogged ENO-30 Mixer
This article outlines a resolution to a clogged mixer in the ENO-30 by sonicating the mixer.
A large Negative Peak Before Nitrite is Interfering With the Nitrite Peak With Biological Samples, What Causes This?
The potential causes and resolution to a large negative peak before the nitrite peak in biological samples are outlined in this article. The negative peak can arise either from the column, autosampler settings, or sample overloading.
My ENO-20/30 NOx Analyzer Shows Error 3
This article outlines the causes for error 03 and the steps to take to fix the issue.